Tire Size Comparison CalculatorCompare two tire sizes side by side before you buy
Enter your current tire size and the size you are thinking of fitting. You get every dimension side by side, the difference in diameter and ground clearance, and how far off your speedometer will read.
Current vs new size
How to use the Tire Size Comparison Calculator
- Enter your current tire size from the sidewall or door jamb sticker, for example 225/65R17.
- Enter the new size you are considering.
- Check the diameter difference. Within ±3% is generally considered safe for most vehicles.
- Look at the speedometer and clearance changes in the table before you buy.
The 3% rule
Tire shops and many manufacturers recommend keeping a replacement tire’s overall diameter within about 3% of the original. Within that range, the speedometer stays close to accurate, the tire is unlikely to rub, and ABS, traction control and automatic transmission shift points are not noticeably affected.
Going bigger than 3% is common on lifted trucks and off-road builds, but it usually needs extra work: a leveling kit or lift, trimming, a speedometer recalibration and sometimes different axle gearing.
What changes when you change tire size
| If the new tire is… | What happens |
|---|---|
| Taller | Speedometer reads low, more ground clearance, slower acceleration, slightly lower engine RPM at cruise. |
| Shorter | Speedometer reads high, less clearance, quicker acceleration, higher RPM at cruise. |
| Wider | More grip in the dry, sharper look, but more road noise, worse fuel economy and higher risk of rubbing. |
| Lower sidewall | Sharper steering, harsher ride, more risk of wheel damage from potholes. |
| Taller sidewall | Softer ride, better pothole protection, a little more body roll. |
Speedometer error explained
Your speedometer counts how fast the wheels turn and assumes the original tire size. A taller tire covers more ground per revolution, so you travel faster than the speedometer shows. A 3% taller tire means 60 mph on the dial is really about 61.8 mph. Your odometer also under-counts miles by the same percentage, which affects fuel economy calculations and service intervals.
Many dealers and tuning shops can recalibrate the speedometer for a new tire size. Some trucks let you change it with an aftermarket programmer.
Before you switch sizes
- Check clearance: turn the wheel to full lock and look at the gap to the fender liner, frame and suspension. Allow for suspension travel.
- Check the rim width: each tire size has an approved range. A tire too wide for the rim bulges; too narrow stretches.
- Match the load index: the new tire must carry at least as much as the original.
- Keep AWD diameters matched: all four tires should be the same size and similarly worn.
- Think about cost: larger tires usually cost more and can lower fuel economy.
The formula behind it
Difference % = (New diameter − Current diameter) ÷ Current diameter × 100
Real speed = Speedometer reading × New diameter ÷ Current diameter
Clearance change = (New diameter − Current diameter) ÷ 2
These are nominal sizes. Actual tires vary slightly by brand and model.
Tire comparison facts
Frequently asked questions
How much bigger can I go on tire size?
Will bigger tires make my speedometer wrong?
Can I put 235 tires instead of 225?
Do bigger tires lower fuel economy?
Does changing tire size affect ABS?
How do I compare a metric size with a flotation size like 33×12.50R17?
Related tools and guides
Shopping for tires?
Read our tire and wheel guides before you buy.
Results are estimates for general information only. Always confirm with your owner’s manual, your lender or a qualified technician before acting on them.
